Siemens SIMOTICS CONNECT 400 - Asset Info (Motor Monitoring) - Step 7;7

Note
Service factor and cooling method
• Service factor according to NEMA MG-1 (if applicable)
• Cooling method according to IEC60034-6
2. Check the data entered and con󹪝rm with the "Send" button.
3. Continue to commission the equipment.
6.2.4.8 Asset Info (Motor Monitoring) - Step 7/7
Note
Settings cannot be modi󹪝ed subsequently
Select the following settings carefully. There is no way of modifying the settings after selection.
If you choose an incorrect setting, repeat the onboarding process.
Commissioning
6.2Commissioning with Android
SIMOTICS CONNECT 400
62 Operating Instructions, 04/2023, A5E50161952B AL