Siemens SIMOTICS CONNECT 400 User Manual

8.5.3 Commissioning the connectivity module after hardware replacement (iOS)
8.5.3.1 Starting the module replacement wizard
You can replace a SIMOTICS Connect 400 connectivity module by a new one using function
"Replace Module". This means that you can still monitor your motor, which was already
registered in SIDRIVE IQ Fleet, without losing any historical data.
The module replacement wizard guides you step-by-step through the replacement process.
Note
Module replacement wizard - Help
You can call help using icon at the speci󹪝c step.
Requirements
• You are logged on to the new connectivity module via the "SIDRIVE IQ Con󹪝g" application.
• You have the necessary authorization (see operating instructions, SIDRIVE IQ Fleet, Section
Activate MindSphere user account > SIDRIVE IQ Fleet roles). If you do not have the required
role, then module replacement is canceled, and error message "Insu󹪟cient rights" output.
Contact your "SIDRIVE IQ Fleet" tenant administrator.
Procedure
1. Start the module replacement wizard using the "Replace Module" button.
8.5.3.2 Device Credentials - Step 1/7
Change the login data for protection against unauthorized access to the connectivity module.
Maintenance
8.5Replacing the connectivity module
SIMOTICS CONNECT 400
Operating Instructions, 04/2023, A5E50161952B AL 157

Siemens SIMOTICS CONNECT 400 Specifications

General

Brand	Siemens
Model	SIMOTICS CONNECT 400
Category	Control Unit
Language	English