Siemens SIMOTICS CONNECT 400 - 1.6 Important product information

1.6 Important product information
1.6.1 Correct use
Description
The products described in this manual, together with software, accessories, and options, form
an electrical power drive system intended to feed low-voltage AC motors. The products are
professional equipment for use in industrial applications. The products must be installed and
maintained by professionals with su󹪟cient knowledge to implement the safety and EMC
measures according to the speci󹪝cations described in this manual and the recognized state
ofthe art.
You may only use the products in compliance with the following requirements:
• All regulations and directives that are applicable at the site of the end use, especially with
regard to electrical safety, functional safety and electromagnetic compatibility.
• All instructions, notes, technical data and safety information contained in this manual and
other supporting documentation.
Before using the products, you must perform a risk assessment of the entire application and
implement appropriate system design measures to ensure safety of persons, property and
electromagnetic compatibility.
Open type products (IP00/IP20) are intended for incorporation within cubicles or enclosures
which will provide necessary protection.
Any use other than the use explicitly permitted is prohibited and can result in unanticipated
hazards.
1.6.2 OpenSSL
Description
This product can contain the following software:
• Software developed by the OpenSSL project for use in the OpenSSL toolkit
• Cryptographic software created by Eric Young.
• Software developed by Eric Young
You can 󹪝nd more information on the internet:
• OpenSSL (
https://www.openssl.org)
• Cryptsoft (https://www.cryptsoft.com)
Introduction
1.6Important product information
SIMOTICS CONNECT 400
16 Operating Instructions, 04/2023, A5E50161952B AL