Siemens SIMOTICS CONNECT 400 - Commissioning with Android; Installing the SIDRIVE IQ Config Application; Establishing the Connection to the Connectivity Module

6.2 Commissioning with Android
6.2.1 Installing the "SIDRIVE IQ Con󹪝g" application
1. Open the Google Play Store. (https://play.google.com/store/apps/details?
id=com.siemens.con󹪝gapp)
2. Install the Siemens "SIDRIVEIQ Con󹪝g" application.
After the 󹪝rst start of the application, the terms of use are displayed once. Take note of them
and click "Accept" to con󹪝rm.
The "SIDRIVEIQ Con󹪝g" application requires the following access authorizations:
– Bluetooth interface
– Localization data (to determine the asset location)
Note: not available in every country
– Camera (to scan the motor data matrix code)
– Memory (to update the 󹪝rmware of the connectivity module (Page130))
SIDRIVE IQ Con󹪝g is available in German, English, French, Italian, Spanish, Turkish and Czech.
The language is automatically preset depending on the system language of your mobile
device. A Chinese version is available for use in China.
6.2.2 Establishing the connection to the connectivity module
Start the "SIDRIVE IQ Con󹪝g" application on your mobile device. The application automatically
activates the Bluetooth interface of your mobile device, and shows active connectivity modules
in a range of approximately 10m. The BLE name (=Bluetooth name of the device) set in the
factory is "SC400". You can change the name at a later point in time.
Use the "Identify" function to check that you are connected with the required connectivity
module (Page114).
Commissioning
6.2Commissioning with Android
SIMOTICS CONNECT 400
38 Operating Instructions, 04/2023, A5E50161952B AL