3. Attach the adhesive to the recommended positions on the inner side of the mounting bracket
(see the blue marked areas in the following diagram). Carefully ensure that no adhesive
enters the threads for the fastening screws.
Note
Handling the adhesive
Follow the handling instructions on the packaging of the adhesive.
The recommended adhesives set quickly. Therefore handle them quickly.
4. Place the mounting bracket on the motor cooling ribs. The short arm of the mounting bracket
must be in complete contact with a cooling rib. The long mounting bracket arm must be in
contact with one or several edges of the cooling ribs.
5. Press the mounting bracket onto the motor cooling ribs using your hand.
6. Allow the adhesive applied to the mounting bracket to dry. Carefully comply with the usage
instructions provided on the adhesive package.
7. Allow the adhesive to completely dry.
Mounting and installation
5.1î™ Installing the mounting bracket
SIMOTICS CONNECT 400
34 Operating Instructions, 04/2023, A5E50161952B AL
To Next Page
Loading...
