Storing outdoors
For outdoor storage, the following additional conditions must be satisfied:
● The ground must be sufficiently strong. Prevent the motor from sinking into the ground.
● Covers or tarpaulins used to protect the equipment against the weather must not make
contact with the surfaces of the equipment. Otherwise air circulation under the stored items
will be prevented.
Protection against humidity
If a dry storage space is not available, protect the machine as follows against humidity:
● Wrap the machine in humidity-absorbent material.
● Wrap the machine in plastic film:
– Place a humidity meter inside the plastic film.
– Place desiccant within the plastic film.
– Pack the machine air-tight.
● Inspect the machine regularly.
If you do not intend to commission the machine immediately, take the following precautions:
● Always keep the terminal box's cover tightly sealed.
● Do not remove the rotor shipping brace device supplied.
● Open the pressure fingers of the brush holders. Take the brushes out of the holders.
● If necessary, reapply the anti-corrosion protection at the shaft extension.
Long-term storage
If you are storing a machine for more than six months, you must check its condition every six
months. Store the machine in accordance with the specifications in Section "Storage
(Page 32)", and if possible, packed.
● Check the motor for damage.
● Carry out any necessary maintenance work.
● Make sure that the storage conditions are such that condensation cannot form in the motor.
● If the machine is not sealed in plastic film, continually and slightly heat the machine, e.g.
with anti-condensation heating (if available), and ensure that the air circulates in the storage
room.
Storage for longer than three months
Lubricate the machine after every two years of storage.
1. Unpack the machine.
2. Remove the rotor shipping brace, if one is being used.
Preparations for use
4.8 Transport and storage
SIMOTICS DC 1GG6
Operating Instructions 02/2016 33
To Next Page
Loading...
Need help?
General