Siemens SINUMERIK 802C base line User Manual

Technical Appendix
SINUMERIK 802C base line
6-9
Start-Up
32910 DYN_MATCH_TIME
– Time constant of dynamic adaption (control parameter set
no): 0...5
NEW_CONF
0 0.0 plus DOUBLE 2/7
32920 AC_FILTER_TIME
s Smoothing factor time constant for adaptive control POWER ON
_always 0.0 0.0 plus DOUBLE 2/7
33050 LUBRICATION_DIST
mm,
deg.
Traversing distance for lubrication from PLC NEW CONF
_always 100000000 0.0 plus DOUBLE 2/7
34000 REFP_CAM_IS_ACTIVE
– Axis with reference point cam RESET
_always 1 *** ***
BOOLEAN
2/7
34010 REFP_CAM_DIR_IS_MINUS
– Approach reference point in minus direction RESET
_always 0 *** ***
BOOLEAN
2/7
34020 REFP_VELO_SEARCH_CAM
mm/min,
rev/min
Reference point approach velocity RESET
_always 5000.0 0.0 plus DOUBLE 2/7
34030 REFP_MAX_CAM_DIST
mm,
deg.
Maximum distance to reference cam RESET
_always 10000.0 0.0 plus DOUBLE 2/7
34040 REFP_VELO_SEARCH_MARKER
mm/min,
rev/min
Creep speed (encoder no.) RESET
_always 300.0 0.0 plus DOUBLE 2/7
34050 REFP_SEARCH_MARKER_REVERSE
– Direction reversal to reference cams (encoder no.) RESET
_always 0 *** *** BOOLEA 2/7
34060 REFP_MAX_MARKER_DIST
mm,
deg.
Maximum distance to reference mark. Max. distance to 2
reference marks
for distance–coded measuring systems.
RESET
_always 20.0 0.0 plus DOUBLE 2/7

Siemens SINUMERIK 802C base line Specifications

General

Brand	Siemens
Model	SINUMERIK 802C base line
Category	Controller
Language	English