Description: Definition of the effects of tool parameters.
Bit no. meaning when bit is set
-----------------------------------------------------------------------------
Bit 0: (LSB):
For turning and grinding tools, the wear parameter of the transverse axis is included
in the calculation as a diameter value.
Bit 1:
For turning and grinding tools, the tool length component of the transverse axis is
included in the calculation as a diameter value.
Bit 2:
If a tool length correction is included in the calculation as a diameter value, the
tool
may only
be used in the plane that was active when the tool was selected. If this
bit is set, a plane change leads to an alarm.
Bit 3:
Work offsets in frames in the transverse axis are included in the calculation as
diameter values.
Bit 4:
PRESET value is included in the calculation as a diameter value
Bit 5:
Include the external work offset in the transverse axis in the calculation as a
diameter value
Bit 6:
Read actual values of the transverse axis as diameter values (AA_IW, AA_IEN, AA_IBN,
AA_IB. Notice: Not AA_IM.)
Bit 7:
Display all actual values of the transverse axis as diameter values, irrespective of
the G code of group 29 (DIAMON / DIAMOF)
Bit 8:
Always display the distance-to-go as a radius in the work coordinate system (Work)
Bit 9:
During DRF handwheel travel of a transverse axis, only half the distance of the
specified
increment is
traveled (on condition that MD11346 $MN_HANDWH_TRUE_DISTANCE =
1).
Bit10:
Activate the tool component of an active, orientable tool holder even if no tool is
active.
Bit11:
The tool parameter $TC_DP6 is not interpreted as a tool radius but as a tool diameter.
Bit12:
The tool parameter $TC_DP15 is not interpreted as wear of the tool radius but as wear
of the tool diameter.
Bit13:
During JOG of circles, the circle center coordinate is always a radius value, see
D42690 $SC_JOG_CIRCLE_CENTRE.
Bit14:
Absolute values of the transverse axis with cycle masks in the radius
Bit15:
Incremental values of the transverse axis with cycle masks as diameter
Bit16:
For GWPS (GWPSON/TMON), the tool parameters, tool length, wear and base dimension, are
interpreted as diameter values
Bit17:
Machine data
3.3 Channel-specific machine data
Parameter Manual
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1 143
To Next Page
Loading...
Need help?
General
