Siemens SINUMERIK 808D ADVANCED Parameter Manual

Description: 0: When incremental programming is used on an axis, only the programmed position
delta is traversed
after a frame change. Work offsets in FRAMES are only traversed when
an absolute position is specified.
1: When incremental programming is used on an axis, changes to work offsets are
traversed after a frame change (standard response up to software version 3).
Related to ....
SD42442 $SC_TOOL_OFFSET_INCR_PROG
42442 TOOL_OFFSET_INCR_PROG - W1, K1
- Tool length compensations BOOLEAN Immediately
-
808d-me42 - FALSE 0 - 2/2 M
808d-me62 - FALSE 0 - 2/2 M
808d-te42 - FALSE 0 - 2/2 M
808d-te62 - FALSE 0 - 2/2 M
808d-mte40 - TRUE, TRUE, TRUE,
TRUE, TRUE, TRUE,
TRUE, TRUE...
0 - 7/7 U
808d-mte60 - TRUE, TRUE, TRUE,
TRUE, TRUE, TRUE,
TRUE, TRUE...
0 - 7/7 U
Description: 0: When incremental programming is used on an axis, only the programmed position
delta is traversed after a frame change. Tool length offsets in FRAMES are only
traversed when an absolute position is specified.
1: When incremental programming is used on an axis, changes to tool length offsets
are traversed after a tool change (standard response up to SW version 3).
Related to ....
SD42440 $SC_FRAME_OFFSET_INCR_PROG
42444 TARGET_BLOCK_INCR_PROG - BA
- Set down mode after search run with calculation BOOLEAN Immediately
-
808d-me42 - TRUE, TRUE, TRUE,
TRUE, TRUE, TRUE,
TRUE, TRUE...
0 - 2/2 M
808d-me62 - TRUE, TRUE, TRUE,
TRUE, TRUE, TRUE,
TRUE, TRUE...
0 - 2/2 M
808d-te42 - TRUE, TRUE, TRUE,
TRUE, TRUE, TRUE,
TRUE, TRUE...
0 - 2/2 M
808d-te62 - TRUE, TRUE, TRUE,
TRUE, TRUE, TRUE,
TRUE, TRUE...
0 - 2/2 M
808d-mte40 - TRUE, TRUE, TRUE,
TRUE, TRUE, TRUE,
TRUE, TRUE...
0 - 7/7 U
808d-mte60 - TRUE, TRUE, TRUE,
TRUE, TRUE, TRUE,
TRUE, TRUE...
0 - 7/7 U
Description: If the first programming of an axis after "Search run with calculation to end of block"
is incremental, the incremental value is added as a function of SD42444
$SC_TARGET_BLOCK_INCR_PROG to the value accumulated up to the search target :
SD = TRUE: Incremental value is added to accumulated position
NC setting data
Parameter Manual
Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1 313

Siemens SINUMERIK 808D ADVANCED Specifications

General

Brand	Siemens
Model	SINUMERIK 808D ADVANCED
Category	Control Unit
Language	English