Machine data
2.3 Channel-specific machine data
Parameter Manual
110
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
Bit 15 = 0:
Active electronic gearboxes remain active.
Bit 15 = 1:
Active electronic gearboxes are canceled.
Bit 16 = 0:
The current setting of the master spindle (SETMS) is retained.
Bit 16 = 1:
Initial setting for the master spindle according to MD20090
$MC_SPIND_DEF_MASTER_SPIND
Bit 17 = 0:
The current setting of the master toolholder (SETMTH) is retained (relevant
only if tool or magazine management is active)
Bit 17 = 1:
Only if MD20124 $MC_TOOL_MANAGEMENT_TOOLHOLDER> 0: Inital setting for the
master toolholder according to MD20124 $MC_TOOL_MANAGEMENT_TOOLHOLDER.
Otherwise, the setting for the master spindle applies.
Bit 18 = 0:
Reference axis for G96/G961/G962 according to MD20100 $MC_DIAMETER_AX_DEF.
When using SCC with its own spindle reset, setting bit 18 = 1 is recommended
(see also MD20110: $MC_RESET_MODE_MASK, bit 18).
Bit 18 = 1:
Reference axis for G96/G961/G962 is retained.
Corresponds with:
MD20120 $MC_TOOL_RESET_VALUE
MD20130 $MC_CUTTING_EDGE_RESET_VALUE
MD20150 $MC_GCODE_RESET_VALUES
MD20152 $MC_GCODE_RESET_MODE
MD20140 $MC_TRAFO_RESET_VALUE
MD20110 $MC_RESET_MODE_MASK
MD20121 $MC_TOOL_PRESEL_RESET_VALUE
MD20118 $MC_GEOAX_CHANGE_RESET
To Next Page
Loading...
