Machine data
2.3 Channel-specific machine data
Parameter Manual
162
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
Description:
The machine data is only intended for diagnostic purposes.
Activating diagnostics
An internal ring buffer records important events.
After a trigger event, with the 'Cancel alarm' key set as default,
the ring buffer is briefly frozen, read, and converted into an ASCII file
in the part program directory. The file name for the 1st channel
is ncsctr01.mpf and for the 7th channel it is ncsctr07.mpf.
The data in the ring buffer is referred to as dynamic data in the following.
In addition to the trigger event, other up-to-date data is read from the
NCK and transferred to the ASCII file. These recordings do
NOT have a history and are referred to as static data in the following.
Bit no. Significance when bit is set
------------------------------------------------------------------
0 (LSB) Recording of dynamic data (see TRACE_VARIABLE_NAME)
1 Recording of block control static data
2 Recording of alarm data static data
3 Recording of process data static data
4 Recording of command sequence static data
5 Recording of tool management static data
6 Recording of the NCK version file. Static data
7 Recording of the statuses of the current block
Various statuses of the axes and the SPARPI. Static data
8 Recording of various statuses of the channel. Static data
9 Error statuses in the NCK memory management are scanned during trace
generation.
An error renames the trace file. Static data
Possible names and their meaning:
NCFIER.MPF Error in the file system
NCSLER.MPF Error during string creation
NCFIER.MPF Error on New/Delete
10 All block changes in the interpreter are recorded. Dynamic data.
11 Axial VDI signals are recorded. Dynamic data.
Only in conjunction with MD18794 $MN_MM_TRACE_VDI_SIGNAL
12 OEM traces are activated. Dynamic data.
13 Synchronized actions are recorded. Dynamic data.
NOTICE: Filled in applications with intensive use of
these trace points, other events are ignored!
That is why this bit should remain at 0 in these cases.
14 Reserved.
15 Recording of station commands. Dynamic data.
Note: Most important output of the NCK module NCSC!
16 Recording of gantry commands
17 Recording of changes in the drive's status
22714 MM_TRACE_DATA_FUNCTION EXP, C02, C06 -
- Activating diagnostics DWORD PowerOn
NBUP
- - 0x0, 0x0, 0x0, 0x0,
0x0, 0x0, 0x0, 0x0...
0 0xFFFFFF 1/1
To Next Page
Loading...
