Siemens SINUMERIK 808D ADVANCED User Manual

Parameter Manual
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
19
Machine data
2.1 Display machine data
Description: Preselection of cycle type on tapping MM+:
With compensating chuck without compensating chuck
0 CYCLE840 CYCLE840
1 CYCLE840 CYCLE84
>=2 CYCLE840 not possible
Description: Tool change enable in the JOG function of the MM+
Description: Automatic start of MM+ after power ON
Description: Text on the softkeys is justified
Description: Activate axis utilization display
Description: DB representation in the PLC ladder viewer
0 - VB representation of the PLC signals
1 - DB representation of the PLC signals
Description: Activate/deactivate PLC ladder editor
0 - No editing functionality for PLC programs
1 - Activate edit functionality for PLC programs
1103 TAPPINGCYCLE_MODE_MANUAL_MA --
- Preselection cycle type for thread tapping MM+ BOOLEAN Immediately
-
-- 1 0 1 3/3
1104 TOOL_CHG_MANUALMODE_MA --
- Enable tool change in the jog function of the MM+ BOOLEAN Immediately
-
-- 1 0 1 3/3
1105 STARTUP_WITH_MMP --
- Automatic start of the MM+ after power on BOOLEAN PowerOn
-
-- 1 0 1 3/3
1106 SOFTKEY_CENTRE_ADJ --
- Softkey text is adjusted BOOLEAN PowerOn
-
-- 1 0 1 3/3
1107 AX_LOAD_DISPL --
- Activate axis utilization display BOOLEAN Immediately
-
-- 1 0 1 3/3
1110 ENABLE_LADDER_DB_ADDRESSES --
- DB representation in the PLC ladder viewer BOOLEAN Immediately
-
-- 1 0 1 7/2
1111 ENABLE_LADDER_EDITOR --
- Activate/deactivate PLC ladder editor BOOLEAN Immediately
-
-- 1 0 1 7/2
Siemens Controls

Siemens SINUMERIK 808D ADVANCED Specifications

General

Brand	Siemens
Model	SINUMERIK 808D ADVANCED
Category	Control Unit
Language	English