NC setting data
Parameter Manual
306
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
Description:
Value not equal to 0:
The speed entered applies to spindles in JOG mode if they are traversed man-
ually by the "Plus and minus traversing keys" or the handwheel. The speed is
active for
• continuous jogging
• incremental jogging (INC1, ... INCvar)
• handwheel traversing. The value entered is valid for all spindles, and
must not exceed the maximum permissible speed (MD32000 $MA_MAX_AX_VELO).
Value = 0:
If 0 has been entered in the setting data, MD32020 $MA_JOG_VELO (JOG axis
velocity) acts as the JOG velocity. Each axis can thus be given its own JOG
velocity with this MD (axial MD).
The maximum speeds of the active gear stage (MD35130
$MA_GEAR_STEP_MAX_VELO_LIMIT) are taken into account when traversing the
spindle with JOG.
SD irrelevant for ......
Application example(s). The operator can thus define a JOG speed for the
spindles for a specific application.
Related to ....
Axial MD32020 $MA_JOG_VELO (JOG axis velocity)
MD35130 $MA_GEAR_STEP_MAX_VELO_LIMIT (maximum speeds of the gear stages)
41200 JOG_SPIND_SET_VELO -H1
rev/min Speed for spindle JOG mode DOUBLE Immediately
-
-- 0.0 0.0 - 7/7
To Next Page
Loading...
Need help?
General
