Machine data
2.2 General machine data
Parameter Manual
46
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
Description:
Default modes of the mode groups after power ON.
If no mode is selected by the PLC, all the channels associated with mode
group n are in the mode preset by OPERATING_MODE_DEFAULT[ n -1 ] after power
ON:
0 = Automatic mode
1 = Automatic mode, submode REPOS
2 = MDI mode
3 = MDI mode, submode REPOS
4 = MDI mode, submode Teach In
5 = MDI mode, submode Reference point approach
6 = JOG mode
7 = JOG mode, submode Reference point approach
8 = AUTO mode, submode Teach In
9 = AUTO mode, submode Teach In, submode Reference point approach
10 = AUTO mode, submode Teach In, submode Repos
11 = MDI mode, submode Teach In, submode Reference point approach
12 = MDI mode, submode Teach In, submode Repos
NOTICE! Depending on the machine data MD10721 $MN_OPERATING_MODE_EXTENDED,
the mode set here might not be adopted after power ON
Description: Extended setting of an operating mode of the operating mode groups after
power on:
0 = Selection of the operating mode according to MD10720
$MN_OPERATING_MODE_DEFAULT
1 = Selection of the JOG mode if the PLC signal "Retract data available"
(DB3300.DBX4005.5) is set in at least one channel of the operating mode group
10720 OPERATING_MODE_DEFAULT N01 H2
- Setting of mode after power ON BYTE PowerOn
-
- 1 7, 7, 7, 7, 7, 7, 7, 7... 0 12 1/1
10721 OPERATING_MODE_EXTENDED N01 H2
- Extended setting of mode after power ON BYTE PowerOn
-
- 1 0, 0, 0, 0, 0, 0, 0, 0... 0 1 1/1
To Next Page
Loading...
