Parameter Manual
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
47
Machine data
2.2 General machine data
Description: Bit 0:
Enables JOG in automatic.
JOG is enabled in automatic when all channels in the mode group are in the
RESET state and no channel of the DRF mode group has been selected. The mode
group changes internally to JOG with the +/- key and the handwheel, and the
axis moves. After the JOG motion has ended, a change back to AUTO is also
made internally.
Bit 1:
Position with AxFrame.
The function 'JOG to position' considers all axial frames and, in the case of
an axis configured as geometry axis, the tool length offset.
Bit 2:
Travel in opposite direction.
The functions 'JOG to position' and 'Approach machine fixed point manually'
allow travel in opposite direction, i.e. away from the specified position.
Bit 3:
Tool radius offset.
MD21020 $MC_WORKAREA_WITH_TOOL_RADIUS is active with JOG motions of the geom-
etry axes.
Bit 4:
Alarm suppression operating range limit in the basic coordinate system in
JOG.
Alarms that would be output in JOG when an operating range limit is reached
in the basic coordinate system, are suppressed.
Bit 5:
Alarm suppression operating range limit in the workpiece coordinate system in
JOG.
Alarms that would be output in JOG when an operating range limit is reached
in the workpiece coordinate system, are suppressed.
Bit 6, 7:
JOG of circles:
Bit 7 and bit 6 = 0: traversing the 2nd geometry axis of the active plane to
PLUS for radius increase, traversing to MINUS for radius decrease indepen-
dently of inner or outer machining being active.
Bit 7 = 1 and bit 6 = 0: traversing the 2nd geometry axis of the active plane
to PLUS always travels in the direction of the limiting circle. This means
that the radius is increased on inner machining and decreased on outer
machining.
Bit 7 = 1 and bit 6 = 1: traversing the 2nd geometry axis of the active plane
to MINUS always travels in the direction of the limiting circle. This means
that the radius is increased on inner machining and decreased on outer
machining.
Bit 8:
Bit 8 = 0 If there is a JOG retract movement, the retraction axis can only be
jogged in the plus direction.
Bit 8 = 1 If there is a JOG retract movement, the retraction axis can only be
jogged in the plus and minus direction.
10735 JOG_MODE_MASK EXP, N01 K1
- Settings for JOG mode DWORD PowerOn
-
- - 0 0 0x1ff 2/2
Siemens Controls
To Next Page
Loading...
