Siemens SINUMERIK 808D ADVANCED User Manual

Machine data
2.2 General machine data
Parameter Manual
68 Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
Description:
The behavior during the action blocks after search run can be affected by the
following bits:
Bit 0 = 0:
Machining is stopped after loading of the last action block after search run,
the NC/PLC interface signal DB3300 DBX0.6 (last action block active) and
alarm 10208 is output.
Bit 0 = 1:
Machining is stopped with the loading of the last action block after search
run, and the NC/PLC interface signal DB3300 DBX0.6 (last action block active)
is set. Alarm 10208 is not output until the PLC requests it by setting the
NC/PLC interface signal DB3200 DBX1.6 (PLC action finished).
Application:
Starting an ASUB from the PLC after search run.
The message to the operator that another NC start is required in order to
continue with the program is not to be displayed until after the end of the
ASUB.
Bit 1 = 1
Automatic ASUB start after output of the action blocks. Alarm 10208 is not
output until the ASUB has finished
also see MD11620 $MN_PROG_EVENT_NAME.
Bit 2 = 0:
Spindle: auxiliary functions are output in the action blocks.
Bit 2 = 1:
The output of the auxiliary functions in the action blocks is suppressed. The
spindle programming collected by search run can be output at a later point in
time (e.g. in an ASUB).
The program data for this are stored in the following system variables:
- $P_SEARCH_S,
- $P_SEARCH_SDIR,
- $P_SEARCH_SGEAR,
- $P_SEARCH_SPOS,
- $P_SEARCH_SPOSMODE
Bit 3 = 1:
The cascaded search run is disabled (default setting: release).
Cascaded search run means that the search run is restarted immediately after
finding a search target.
Bit 4:Reserved
Bit 5 = 0:
During block search on a nibbling block, the 1st nibbling stroke is not exe-
cuted.
Bit 5 = 1:
During block search on a nibbling block, a punching stroke is triggered at
block start (1st nibbling stroke).
11450 SEARCH_RUN_MODE EXP, N01 K1,TE3,N4,H2,Z1
- Parameterization for search run DWORD PowerOn
-
-- 0 0 0x3F 1/1

Siemens SINUMERIK 808D ADVANCED Specifications

General

Brand	Siemens
Model	SINUMERIK 808D ADVANCED
Category	Control Unit
Language	English