Machine data
2.3 Channel-specific machine data
Parameter Manual
98
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
Description:
This MD is used to define a geometry axis as a transverse axis. Only one
transverse axis can be defined here for each channel.
Further transverse axes for axis-specific diameter programming can be acti-
vated via MD30460 $MA_BASE_FUNCTION_MASK, bit 2.
The axis identifier of an active geometry axis that has been defined in the
channel-specific MD20050 $MC_AXCONF_GEOAX_ASSIGN_TAB[n]
or MD24120 $MC_TRAFO_AX_GEOAX_ASSIGN_TAB_1[n] (from SW 4) and
MD20060 $MC_AXCONF_GEOAX_NAME_TAB[n] must be specified.
If space characters are entered or if an axis identifier is specified for an
axis which is not defined as a geometry axis, this leads to the following
alarms:
• during runup, to alarm 4032 "Channel %1 wrong identifier for transverse
axis in %2", if the "Diameter programming" function (DIAMON) or constant
cutting velocity G96/G961/G962 is the switch-on setting.
• when the "Diameter programming (DIAMON)" function is activated, to alarm
16510 "Channel %1 block %2 No transverse axis available for diameter pro-
gramming", if no axis has been permitted via DIAMCHANA[AX] for channel-
specific diameter programming.
• when G96/G961/G962 has been programmed, to alarm 10870 "Channel %1 block
%2 No transverse axis defined as reference axis for G96/G961/G962", if no
geometry axis has been defined as the reference axis for G96/G961/G962 by
the instruction SCC[ax].
Related to:
MD20050 $MC_AXCONF_GEOAX_ASSIGN_TAB[n]
MD20060 $MC_AXCONF_GEOAX_NAME_TAB[n]
MD24120 $MC_TRAFO_AX_GEOAX_ASSIGN_TAB_1[n]
MD30460 $MA_BASE_FUNCTION_MASK
20100 DIAMETER_AX_DEF C01, C10 H1,M5,P1,V1,W1
- Geometry axis with transverse axis function STRING PowerOn
-
808d-me42 - ... - - 1/1
808d-me62 - ... - - 1/1
808d-te42 - X - - 1/1
808d-te62 - X - - 1/1
To Next Page
Loading...
