Mounting slots for control devices
WARNING
Warning of damage
Do not chip out the openings for mounting control devices ⑥; drill them to the required width.
Key caps
All keys of the MCP 310C PN come with changeable key caps. Refer to the following table for
the additional replacement key caps provided for lathes in the accessories pack:
Key cap Symbol number Key cap Symbol number
7027 7129
7125 7130
7126 7131
7127 7132
7128
You will find article numbers for the key caps in Chapter Spare parts and accessories
(Page 127).
Connectable components
7.2 MCP 310C PN
PPU
114 Manual, 01/2014, 6FC5397-2DP40-3BA3
To Next Page
Loading...
Need help?
General
