04/96
Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–156
SINUMERIK 840C / SIMODRIVE 611–D (DA)
160082 Illegal signal type OK softkey
Function generator parameterization
The function cannot be started
The selected function is not possible with this signal
Change signal type
160083 Value not allowed OK softkey
Startup application
The function is not executed
The value concerned is not within the permissible value range (negative acknowledgement with variables service)
Correct input
160084 Value > maximum value OK softkey
Function generator/measuring function parameterization
The function cannot be started
The value in question exceeds the permissible maximum value
Enter lower value
160085 Value < minimum value OK softkey
Function generator/measuring function parameterization
The function cannot be started
The value in question is below the permissible minimum value
Enter larger value
160086 Max. acceleration too large OK softkey
Initialization value too large
Fine quantization too large
Number of learning runs too large
S Reparameterization of the maximum acceleration (function parameters of the neural quadrant error compensa-
tion)
S Reparameterization of the initialization value (function parameters of the neural quadrant error compensation)
S Reparameterization of the fine quantization (function parameters of the neural quadrant error compensation)
S Reparameterization of the number of learning runs (function parameters of the neural quadrant error compen-
sation)
Start-up function aborts
S a) The maximum working area has been entered as a value that is greater than allowed in MD 276* and the
function generator has been started with this.
b) The maximum working area exceeds internal format limits (even without function generator start)..
S The initialization value of the neural quadrant error compensation is limited to 1% of the maximum speed in
order to prevent uncontrolled injections during the learning phase if the network has not yet established the
characteristic. In the 1st learning run, this value is used as injection amplitude.
S The fine quantization must be greater than/equal to 4 and less than/equal to 32.
S The number of learning runs must not be less than 5 or greater than 40.
S Enter a smaller value in the function parameter max. acceleration.
S Enter a value between 0 and 1% (resolution 0.001%).
S Enter a valid value in the fine quantization.
S Enter a valid value.
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description
To Next Page
Loading...
