Siemens SINUMERIK 840C - Page 166

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–158
SINUMERIK 840C / SIMODRIVE 611–D (DA)
160093 File ... not saved completely OK softkey
Startup application file services (write)
Incomplete data set created
File contents not completely transferred
Repeat procedure
160094 File ... does not exist OK softkey
Startup application file services (read only)
No data is read
The stated file does not exist
Correct file selection
160095 Error on reading from file ... OK softkey
Startup application file services (read only)
No data or only inconsistent data are read
Bulk storage device access problems
Contact service
160096 Error in file structure ... OK softkey
Startup application file services (read only)
No data read in
File does not have correct format
None
160097 Hard disk full, write file ... OK softkey
Startup application file services (write)
No data or only inconsistent data are written
Bulk storage device access problems
Remove files not required
160098 Data block of file ... not available OK softkey
Startup application file services (read only)
No data read in
The file does not contain any data for the selected axis/drive
None
160099 File ... not loaded OK softkey
Startup application file services (read only)
No data is read in
–
Repeat procedure
160100 File ... not saved OK softkey
Startup application file services (write)
Data set is not stored
–
Repeat procedure
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description