04/96
Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–160
SINUMERIK 840C / SIMODRIVE 611–D (DA)
160108 No trace activated OK softkey
Start-up application at start of SERVO TRACE function
SERVO trace is not started
All traces are switched passive or no signal selected
Switch at least one trace to active
Applies as from SW 4
160109 Trace buffer already assigned ... OK softkey
Start-up application at start of SERVO TRACE function
SERVO trace is not started
Trace buffer assigned by measuring function
Stop measuring function and restart Trace
Applies as from SW 4
160110 Illegal NC No. ... OK softkey
Start-up application at start of SERVO TRACE function
SERVO trace is not started
NC No. is illegal
Specify axis name for a valid NC axis/spindle
Applies as from SW 4
160111 Illegal component ... OK softkey
Start-up application at start of SERVO TRACE function
SERVO trace is not started
Component is illegal
Specify valid component (SERVO)
Applies as from SW 4
160112 Illegal signal selection ... OK softkey
Start-up application at start of SERVO TRACE function
SERVO trace is not started
Signal number is illegal
Specify valid signal number
Applies as from SW 4
160113 Illegal segment address ... OK softkey
Start-up application at start of SERVO TRACE function
SERVO trace is not started
Segment address is illegal
Specify legal segment address
Applies as from SW 4
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
1 Alarms
1.5.1 Alarm description
To Next Page
Loading...
