04/96
Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–161
SINUMERIK 840C / SIMODRIVE 611–D (DA)
160114 Illegal offset address ... OK softkey
Start-up application at start of SERVO TRACE function
SERVO trace is not started
Offset address is illegal
Specify legal offset address
Applies as from SW 4
160115 Illegal measurement duration ... OK softkey
Start-up application at start of SERVO TRACE function
SERVO trace is not started
Measuring duration is illegal
Specify legal measuring duration
Applies as from SW 4
160116 Illegal trigger time ... OK softkey
Start-up application at start of SERVO TRACE function
SERVO trace is not started
Trigger time is illegal
Specify legal trigger time
Applies as from SW 4
160117 Illegal mode ... OK softkey
Start-up application at start of SERVO TRACE function
SERVO trace is not started
Mode is illegal
Specify legal mode (0)
Applies as from SW 4
160118 Illegal trigger condition ... OK softkey
Start-up application at start of SERVO TRACE function
SERVO trace is not started
Trigger condition is illegal
Specify legal trigger condition
Applies as from SW 4
160119 Conversion error ... OK softkey
Start-up application when converting the TRACE buffer
Signal values in the Trace buffer could not be converted
–
–
Applies as from SW 4
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
1 Alarms
1.5.1 Alarm description
To Next Page
Loading...
