04/96
Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–163
SINUMERIK 840C / SIMODRIVE 611–D (DA)
160126 Data not available on Servo OK softkey
Start-up application at SK display and SK file function. Save with neural QEC or SK stop at Servo Trace.
The characteristic of the neural QEC for the selected axis is not loaded from the Servo side to the MMC side. With
Servo Trace, the data are not loaded to the MMC side.
The data characteristic is not yet available on the Servo side.
Enter the function parameters of the neural QEC for the axis and start the learning process or press the parameter
transfer softkey. The characteristic is then available. With Servo Trace, parameterize correctly (observe the trigger
conditions) and restart.
Applies as from SW 4
160127 Illegal channel / IKA No.
Start-up applications when starting the servo-trace function for NCK signals.
Servo-trace is not started.
Enter permissible channel/IKA No. and restart.
Alarm in SW 5 and higher
161001 Function abort by the operator OK softkey
Startup function
None
Operational message after operator action
Stop Servo Trace and restart measurement function
161002 Function abort by SERVO error ...
Startup application
Current startup function aborted
A system error has caused the active function to terminate
The following errors (No. and meaning) are possible:
81 “Axial alarm active”
82 “Above traversing range upper limit”
83 “Below traversing range lower limit”
84 “No axial SERVO enable”
85 “No PLC enable”
86 “SERVO mode change”
87 “MF on SERVO aborted”
88 “Reset”
89 Axis/spindle not in stop state”
90 Spindle ramp-up encoder stop from PLC”
End application and restart
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description
To Next Page
Loading...
