04/96
Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–51
SINUMERIK 840C / SIMODRIVE 611–D (DA)
3038 Double call of display Acknowledgement key
On selecting the display
Display build-up is aborted with the display that is repeatedly called in the same path.
In a display, additional subdisplays can be configured which themselves can have subdisplays. If a display is cal-
led which does not correspond to a display already configured, recursion results. This is prevented by aborting the
display build-up and issuing an alarm.
Avoid subdisplay linking which can lead to recursion.
3039 No multichannel display option Acknowledgement key
S Cyclic
S Fixed display parts only are displayed
If data which is reserved for multi-channel display is configured in a display, it can be displayed correctly only if the
multi-channel display option is available.
Set multi-channel display option.
3040 Field/variable cannot be displayed Acknowledgement key
S Cyclic
S Not all variable values/texts are displayed
S Field/variable incorrectly configured
(data group not available)
S Field/variable programmed with too few places
S Field/variable overflow (value range exceeded)
S Format error; format cannot be changed
S Illegal pointer
S Check field/variable with NC workstation and if appropriate delete and re-enter.
If the alarm occurs with standard displays then the value range has been exceeded.
3041 Too many fields/variables Acknowledgement key
S Cyclic
S Not all values/texts are displayed
S The display description is too long so that the internal buffer is no longer adequate for processing the display.
S More than one display (main displays/secondary displays) have been configured with data selector.
S Using the NC workstation, the desired information must be reduced or divided amongst more than one display.
A maximum number of fields/variables cannot be specified since the fields/variables have different formats and
positions.
S Configure only one display with data selector in conjunction with other displays.
3042 Error in dynamic graphics section Acknowledgement key
S Cyclic
S Dynamic graphics (columns) not entirely displayed
The column graphics configured at the NC workstation are too extensive. A maximum of 4 Kbytes are available for
the whole cyclic part of the display (variable part of display including dynamic graphics) for all displays and insets.
Reconfigure the display at the NC workstation, reduce the variable display parts and dynamic graphics.
3043 Error: NCK fixed display to MMC Acknowledgement key
S On display selection
S Not all fixed texts are displayed
An error has occurred during transmission of fixed texts e.g.: delete window, fixed texts, etc. from NCK to MMC.
Activate notebook for I code and send message to
S System Support (system program change required)
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description
To Next Page
Loading...
Need help?
General
