No. Parameter
mask
Parameter
internal
Data type Meaning
31 <_AMODE> INT Alternative mode
UNITS: Select infeed
0 = DX and DZ infeed for stock re‐
moval parallel to contour
1 = D infeed
TENS: Infeed strategy
0 = Variable cutting depth (90 ...
100%)
1 = Constant cutting depth
HUNDREDS: Cut segmentation
0 = Uniform
1 = Align to edges
THOUSANDS: Select contour allowance U1, double fin‐
ishing
0 = No
1 = Yes
TEN THOUSANDS: Update selection of blank
0 = No
1 = Yes
HUNDRED THOUSANDS: Select allowance on blank XD
0 = Absolute, value of transverse ax‐
is in the diameter
1 = Incremental, value of transverse
axis in the radius
ONE MILLION: Select allowance on blank ZD
0 = Absolute
1 = Incremental
TEN MILLIONS: Select limit 2 XB
0 = Absolute, value of transverse ax‐
is in the diameter
1 = Incremental, value of transverse
axis in the radius
HUNDRED MILLION: Select limit 2 ZB
0 = Absolute
1 = Incremental
ONE BILLION:
0 = Leading channel
1 = Following channel
32 <_PK> INT Number of the partner channel if there are more than two channels
available at the machine.
33 DCH <_DCH> REAL Channel offset
34 FS <_FS> REAL Finishing feedrate during complete machining
Work preparation
3.25 Programming cycles externally
NC programming
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0 1129
To Next Page
Loading...
