● 1 second sparking-out time
● Standard geometry axes
Program code
N10 T1 D1
N20 CYCLE4079(0.02,0.01,1,100,1,1000,1)
N30 M30
3.25.1.53 GROUP_BEGIN - beginning of program block
Syntax
GROUP_BEGIN(<_LEVEL>, <_NAME>, <_SP>, <_MODE>, <S_ICON>)
Parameter
No. Parameter
mask
Parameter
internal
Data type Meaning
1 <_LEVEL> INT Level
0 = Main level
1 = 1st sublevel
2 <_NAME> STRING[128] Block name
3 <_SP> INT Spindle
0 = No spindle
1 = Main spindle
2 = Counterspindle
4 <_MODE> INT Mode
Bit 0 = 1 GROUP_ADDEND exists
Bit 1 = 1 ShopTurn: Automatic retraction (traverse to tool
change point)
Bit 12 Reserved
Bit 13 Reserved
5 <S_ICON> STRING[32] Name of the icon (only for operator interface)
3.25.1.54 GROUP_END - end of program block
Syntax
GROUP_END(<_LEVEL>, <_SP>)
Work preparation
3.25 Programming cycles externally
NC programming
1152 Programming Manual, 12/2019, 6FC5398-2EP40-0BA0
To Next Page
Loading...
