Siemens SINUMERIK 840DE SL

2.15.2 From travel command to machine movement
The relationship between the programmed axis movements (travel commands) and the
resulting machine movements is illustrated in the following figure:
$[LVPRYHPHQWSURJUDPPHGLQWKHZRUNSLHFHFRRUGLQDWHV\VWHP
'HVFULSWLRQRIWKH
ZRUNSLHFHJHRPHWU\YLDJHRPHWU\
D[HVHJ;<=
&RQWRXULQWKH&DUWHVLDQ
FRRUGLQDWHV\VWHP
RIWKHFKDQQHO%&6
7RROUDGLXVFRPSHQVDWLRQ
0RYHPHQWRIWKH
WRRO]HUR
LQWKH%&6
7RROOHQJWKFRPSHQVDWLRQ
.LQHPDWLFWUDQVIRUPDWLRQLIDFWLYH
0RYHPHQWRIWKHPDFKLQHD[HVRIFKDQQHODEF
5RWDU\D[HVIRUD[LV
WUDQVIRUPDWLRQ
5HPDLQLQJWUDYHUVLQJ
FRPPDQGVYLDVRFDOOHG
VSHFLDOD[HVHJ&89
'HVFULSWLRQRIWKHWRRO
RULHQWDWLRQYLDRULHQWDWLRQ
YHFWRU(XOHUDQJOH
)UDPHFDOFXODWLRQ
2IIVHW75$16
5RWDWLRQ527
6FDOLQJ6&$/(
)UDPHFDOFXODWLRQ
2IIVHW
6FDOLQJ
2.15.3 Path calculation
The path calculation determines the distance to be traversed in a block, taking into account all
offsets and compensations.
In general:
Path =
setpoint - actual value + zero offset (ZO) + tool offset (TO)
$EVROXWHSRVLWLRQ
6HW
SRLQW
6HWSRLQW
$EVROXWHSRVLWLRQ
;
=0:
19
:.
:.
7
Fundamentals
2.15 Other information
NC programming
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0 379