4.3.53 G group 53: Frame rotation in relation to tool ....................................................................1263
4.3.54 G group 54: Vector rotation for polynomial programming ..................................................1263
4.3.55 G group 55: Rapid traverse with/without linear interpolation..............................................1264
4.3.56 G group 56: Taking into account tool wear ........................................................................1264
4.3.57 G group 57: Corner deceleration........................................................................................1264
4.3.58 G group 59: Dynamic response mode for path interpolation..............................................1264
4.3.59 G group 60: Working area limitation...................................................................................1265
4.3.60 G group 61: Tool orientation smoothing.............................................................................1265
4.3.61 G group 62: Repositioning mode for REPOS (non-modal) ................................................1265
4.3.62 G group 64: Grinding frames..............................................................................................1266
4.4 Predefined procedures.......................................................................................................1267
4.5 Predefined procedures in synchronized actions ................................................................1288
4.6 Predefined functions ..........................................................................................................1290
4.7 Currently set language in the HMI......................................................................................1303
A Appendix.................................................................................................................................................1305
A.1 List of abbreviations ...........................................................................................................1305
A.2 Documentation overview....................................................................................................1314
Index.......................................................................................................................................................1315
Table of contents
NC programming
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0 21
To Next Page
Loading...
