5. String "$MC_GCODE_RESET_VALUES" is defined as machine data:
206 == STRINGIS("$MC_GCODE_RESET_VALUES")
6. String "GETMDACT" is an NC language function:
203 == STRINGIS("GETMDACT ")
7. String "DEFINE" is a keyword:
205 == STRINGIS("DEFINE")
8. String "$TC_DP3" is a system parameter (tool length component):
207 == STRINGIS("$TC_DP3")
9. String "$TC_TP4" is a system parameter (tool size):
207 == STRINGIS("$TC_TP4")
10.String "$TC_MPP4" is a system parameter (magazine location state):
– Tool magazine management is active: 207 == STRINGIS("$TC_MPP4") ;
– Tool magazine management is not active: 000 == STRINGIS("$TC_MPP4")
Also refer to the paragraph below: Tool magazine management.
11.String "MACHINERY_NAME" is defined as GUD variable:
209 == STRINGIS("MACHINERY_NAME")
12.String "LONGMACRO" is defined as macro:
210 == STRINGIS("LONGMACRO")
13.String "MYVAR" is defined as LUD variable:
211 == STRINGIS("MYVAR")
14.String "XYZ" is a command that is not known in the NC, GUD variable, macro or cycle name:
000 == STRINGIS("XYZ")
Tool magazine management
If the tool magazine management function is not active, supplies STRINGIS for the system
parameters of the tool magazine management, independent of the machine data
● MD10711 $MN_NC_LANGUAGE_CONFIGURATION
always a value of 000.
ISO mode
If the "ISO mode" function is active:
● MD18800 $MN_MM_EXTERN_LANGUAGE (activation, external NC languages)
● MD10880 $MN_ MM_EXTERN_CNC_SYSTEM (control system to be adapted)
STRINGIS checks the specified string initially as SINUMERIK G command. If the string is not
a SINUMERIK G command, then it is subsequently checked as ISO G command.
Programmed switchovers (G290 (SINUMERIK mode), G291 (ISO Mode)) have no effect on
STRINGIS.
Work preparation
3.23 Additional functions
NC programming
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0 991
To Next Page
Loading...
