Siemens SINUMERIK 840DE SL

[NCU840D_2]
ADDRESS0=192.168.214.2,LINE=14,NAME=/NC,SAP=040d,
PROFILE=CLT1__CP_L4_INT
ADDRESS1=192.168.214.2,LINE=14,NAME=/PLC,SAP=0202,
PROFILE=CLT1__CP_L4_INT
ADDRESS2=192.168.214.2,LINE=14,NAME=/CP,SAP=0502,
PROFILE=CLT1__CP_L4_INT
ADDRESS10=192.168.214.2,LINE=14,NAME=/DRIVE_00_000,SAP=0201,
SUBNET=0000-00000000:000,PROFILE=CLT1__CP_L4_INT
ADDRESS11=192.168.214.2,LINE=14,NAME=/DRIVE_03_003,SAP=0900,
PROFILE=CLT1__CP_L4_INT
Example netnames.ini
;******************************************************************
; netnames.ini - EXAMPLE -
;
; This is an example of a netnames.ini for 1:N NCU-switching in
; a configuration of 3 NCU and a PCU50.
;*******************************************************************
[own]
owner = HMI
;***************************
; ChanMenu
;***************************
[chan HMI]
ShowChanMenu = true
;*******************************************************************
;Channel-groups
;Correlation from channel-group to horizontal softkeys
; -> see config.ini of the TCU
;The section [T2M2N] can also be created in the netnames.ini file
;instead of config.ini file. This configuration applies to all TCU,
;which are not configured by their config.ini.
;*******************************************************************
[T2M2N]
SK1 = CH_GRP_1
SK2 = CH_GRP_2
[CH_GRP_1]
Text = 1. NCU
Member1.Target = 192.168.214.241.192.168.214.1.#1
Member1.Text = NCU1%nKanal 1
Member2.Target = 192.168.214.241.192.168.214.1.#2
Member2.Text = NCU1%nKanal 2
[CH_GRP_2]
Channel menu
6.6 Example: Settings for 1:N
SINUMERIK Operate (IM9)
90 Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1