Siemens SINUMERIK 840DE SL

</message>
<!-- **** Headline for own parameter *** -->
<!-- **** Priority tool *** -->
<message>
<source>TMO_HL_PRIOR_TOOL</source>
<translation>V</translation>
<remark>priority tool</remark>
<chars>1</chars>
<lines>2</lines>
</message>
<!-- **** Tooltip for own parameter *** -->
<!-- **** Priority tool *** -->
<message>
<source>TMO_TT_PRIOR_TOOL</source>
<translation>priority tool, %nuse tool preferably< /translation>
<chars>35</chars>
<lines>3</lines>
</message>
<!-- **** OEM cutting edge parameter 1 headline *** -->
<!-- **** Maximum tool width *** -->
<message>
<source>TM_HL_EDGE_USER_1</source>
<translation>maximum%nwidth</translation>
<chars>8</chars>
<lines>2</lines>
</message>
<!-- **** OEM cutting edge parameter 1 tooltip *** -->
<!-- **** Maximum tool width *** -->
<message>
<source>TM_TT_EDGE_USER_1</source>
<translation>maximum width%nof the tool%noverall</translation>
<chars>35</chars>
<lines>2</lines>
</message>
<!-- ************************************************************** -->
<!-- Enter your text ahead of this comment -->
<!-- ************************************************************** -->
</context>
</TS>
Tool management
12.4 Examples
SINUMERIK Operate (IM9)
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1 237