Siemens SINUMERIK HT 10 User Manual

Ambient conditions Application areas Remarks
Relative humidity (with‐
out condensation)
5% to 95% (60% when corrosive gases and/or dusts are present)
Condensation, icing,
drip, spray and splash
water
Not permitted
Max. installation alti‐
tude
Up to 4 000 m (13 123 ft) above sea level
Air pressure 620 ... 1060 hPa
Biological, chemical and mechanical in󹪞uences, pollutants
Biological environmental conditions Class 3B1 according to EN 60 721‑3‑3:
Mold, mold growth, slime, rodents, termite and other
animal vermin are not permissible.
Mechanically active environmental conditions Class 3S1 according to EN 60721‑3‑3:
Conductive dust not permitted.
Classi󹪝cation of the mechanical
environment
3M3 for components on the machine
3M1 / 3M2 for components in the control cabinet
Vibratory load Frequency range: 10 ... 150 Hz
De󹪞ection at 10 – 58 Hz: 0.075 mm
Acceleration at 58 ... 150 Hz: 1 g
Shock load with shock-sensitive components Acceleration: 5 g
Shock duration: 30 ms
Load: 3 x in each direction
Pollution degree 2 (for indoor use only)
Type of enclosure Type 1
Overvoltage category OVC 2
EMC conducted / radiation Class C2 according to EN 61800-3
1) At an ambient air temperature of 45 °C, exposed parts of the device may heat up to 65 °C.
Note
The user must consider radio interference for the complete system. Particular attention should
be paid to cabling. Please contact your sales representative for assistance and support.
Note
In a residential environment, this product can cause high-frequency interference, which may
make interference suppression measures necessary.
• Have the installation and commissioning with appropriate radio interference suppression
measures performed by quali󹪝ed personnel.
Technical speci󹪝cations
7.5 Climatic and mechanical ambient conditions
Handheld Terminal HT 10
88 Equipment Manual, 09/2020, A5E47430965B AA

Siemens SINUMERIK HT 10 Specifications

General

Brand	Siemens
Model	SINUMERIK HT 10
Category	Touch terminals
Language	English