Siemens SINUMERIK MCP-S Series - EMF Assessments for 24 V Components; SINUMERIK South Korea Information; Standards and Approvals

8.1.4 EMF assessments for 24 V components
The 24 V components, e.g. control systems (NCU, MCU, PPU), PCUs/IPCs, operator panels,
handheld terminals and machine control panels do not generate any appreciable
electromagnetic 󹪝elds.
No minimum clearance has to be maintained for 24 V components.
8.1.5 SINUMERIK South Korea information
EMC limit values in South Korea
The EMC limit values to be complied with for South Korea correspond to the limit values of the
EMC product standard for variable-speed electric drives EN 61800-3, Category C2, or limit value
class A, Group 1 according to EN 55011. By applying suitable supplementary measures, the limit
values according to Category C2 or according to limit value class A, Group 1, are maintained.
Further, additional measures may be required, for instance, using an additional radio
interference suppression 󹪝lter (EMC 󹪝lter).
The measures for EMC-compliant design of the system are described in detail in this manual
respectively in the Installation Guideline EMC.
Please note that the 󹪝nal statement on compliance with the standard is given by the respective
label attached to the individual unit.
8.2 Standards and approvals
Figure 8-1 CE marking
The operator panels and the safety-relevant accessories satisfy the requirements and protection
objectives of the following EC directives. The operator panels and the safety-relevant accessories
comply with the harmonized European standards (EN), promulgated in the O󹪟cial Journals of
the European Community:
• 2014/30/EU "Electromagnetic Compatibility" (EMC Directive)
• Directive 2011/65/EC on the restriction of the use of certain hazardous substances in
electrical and electronic devices (RoHS II)
Technical data
8.2 Standards and approvals
ONE MCP Part 1: MCP xxxx
58 Equipment Manual, 07/2020, A5E50324729B AA