Siemens SIRIUS 3RW5 - Page 106

Appendix
A.10 TCP/IP Interface Object
SIRIUS 3RW5 EtherNet/IP communication module
106 Manual, 05/2019, A5E45131885002A/RS-AA/001
The following table describes the attribute ID 1 "Status":
Bit
Query
Definition
0 ... 3 Interface Configuration Status Indicates the status of the characteristic of the interface
configuration:
0 = The characteristic of the interface configuration was not
configured.
1 = The characteristic of the interface configuration contains a
configuration by a BOOTP server, DHCP server or a non-volatile
memory.
2 = The IP address, as part of the characteristic of the interface
configuration, is set on the hardware (e.g. setting wheel).
4 Mcast Pending 0 = A change of the following configuration is not impending: TTL
value and/or characteristic of the Mcast Config.
1 = A change of the following configuration is impending: TTL value
and/or characteristic of the Mcast Config. The change is accepted on
the next restart.
5 Interface Configuration Pending 0 = A change of the following configuration is not impending:
Characteristic of the interface configuration.
1 = A change of the following configuration is impending:
Characteristic of the interface configuration. The device has to be
restarted to accept the change.
6 AcdStatus 0 = ACD has not detected an IP address conflict.
1 = ACD has detected an IP address conflict. For this purpose, ACD
must be supported and activated by the device.
7 AcdFault 0 = ACD has not detected an IP address conflict.
1 = ACD has detected an IP address conflict. Because of the
conflict, the current interface configuration cannot be used.
8 IANA Port Admin Change Pending 0 = A change of the following configuration is not impending:
Characteristic of the IANA Port management.
1 = A change of the following configuration is impending:
Characteristic of the IANA Port management. The device has to be
restarted to accept the change.
9 IANA Protocol Admin Change Pending 0 = A change of the following configuration is not impending:
Characteristic of the IANA Protocol management.
1 = A change of the following configuration is impending:
Characteristic of the IANA Protocol management. The device has to
be restarted to accept the change.
10 ... 31
Reserved
0