Mounting/removal
3.3 Inrush current limiter
SITOP expansion modules
Equipment Manual, 09.2022, A5E36605235-2-76
53
3.3.2 SITOP inrush current limiter
The device can be mounted in a control cabinet on standard mounting rails (see Chapter
Mechanical system (Page 93)).
Mounting
To snap on, attach the device to the top of the mounting rail (I), press down gently (II), press-
in the lower side (III) and snap it into place (IV).
Removing
To remove the device, press it downwards and release it from the mounting rail.
Figure 3-8 Mounting/removal
To Next Page
Loading...
