Siemens SITOP PSE202U - Inrush Current Limiter; Logo! ICL230; SITOP Inrush Current Limiter

Installation
5.2 Output connections
SITOP expansion modules
Equipment Manual, 09.2022, A5E36605235-2-76
85
5.2.3 Inrush current limiter
5.2.3.1 Logo! ICL230
The power supply to be supplied is connected at the output terminals of the inrush current
limiter.
Figure 5-17 Output
5.2.3.2 SITOP inrush current limiter
The power supply to be supplied is connected at the output terminals of the inrush current
limiter.
Figure 5-18 Output
Depending on the particular application, the output terminals should be connected as shown
in the wiring diagram (see Figure 5-8 Wiring diagram (Page 78))
Note
For 3
-phase applications, the N conductor is only connected on the input side to supply the
inrush current limiter itself. It is not permissible that N is connected on the output side.