Siemens Sitrans F Series - Device documentation package; Items supplied

Introduction
1.2 Safety Notes
FUT1010 IP65 NEMA 4X & IP66 NEMA 7 Liquid Quick Start
Operating Instructions, 1/2013, A5E02639182-AC
9
Transmitter Markings and Explanations
●
II (1) G [Ex ia] IIC – Transmitter located in the non-hazardous area with intrinsically
safe circuits of category Ex ia, which can be connected to Category 1 Sensors
●
II 3 (1) G Ex nC [ia] IIC T5 – Category 3 Transmitter located in Zone 2 for use in
nst liquid,
xplanations
potentially explosive atmosphere containing gases with intrinsically safe circuits of
category Ex ia, which can be connected to Category 1 Sensors in Zone 0
● IP65 – Ingress protection against solid bodies, rating of dust-tight and agai
rating of water jets
Sensor Markings and E
●
II 1 G Ex ia IIC T5 – Category 1 Sensors located in Zone 0 potentially explosive
atmosp osive
atm
Safety Information f
Ratings under this heading apply to specific model families.
Model Number: FUT1010, 7ME362x.
here w
ith intrinsically safe circuits of category Ex ia for use in potentially expl
osphere containing gases
or Hazardous Areas
Note
Check Your
FM-CSA installation
Read, understand and follow all safety instruction on the electronic media provided. This
r use in hazardous (classified) locations as stated below and must be
l
● Explosionproof for Class I, Division1, Groups B, C, D;
ionproof for Class II, Division 1, Groups E, F and G;
, B, C, D, E, F and G;
● Intrinsically safe connections Class I and II, Division 1, Groups A, B, C, D, E, F and G;
endive for Class I, Division 2, Groups A, B, C and D;
● Temperature code T6 at an ambient of 40°C
equipment is rated fo
installed according to the 1010-443 installation drawing provided on the media. Failure to
install the equipment in the prescribed manner will result in unsafe operation. Follow all loca
jurisdictional safety codes when operating this equipment. When properly installed the
equipment meets the following FM – CSA ratings:
Transmitter
● Dust-ignit
● Intrinsically safe for Class I and II, Division 1, Groups A
● Nonincendive for Class I, Division 2, Groups A, B, C and D;
● Suitable for Class II, Division 2, Groups E, F and G outdoor (Type 4X), Class III (CSA
only)
Sensors
● Noninc
● Suitable for Class II, Division 2, Groups E, F and G outdoor (Type 4X), Class III (CSA
only)