Installing/mounting
2.2 Mounting the Transmitter
FUT1010 IP65 NEMA 4X & IP66 NEMA 7 Liquid Quick Start
14 Operating Instructions, 1/2013, A5E02639182-AC
Pipe Mounting
For installation on 2-inch (6 cm) mounting pipe use Pipe Mount Kit CQO:1012NMB-1
(optional - see catalog). See figure below.
Note
Pipe mounting kit CQO:1012NMB
-1 is not available for IP66 NEMA 7 enclosures.
① 2-in (6cm) pipe ④ Cable Entry Ports
② Transmitter ⑤ Mounting Flange (also use for wall mounting)
③ Mounting Plate ⑥ U-Bolt Assembly for standard 2-in (6 cm) mounting pipe
Figure 2-1 Pipe Mounting and Mounting Locations for Transmitter
Note
Use conduit fittings or cable glands on all cables.
To Next Page
Loading...
