Siemens Sitrans F Series - Wizards

FUT1010 IP65 (NEMA 4X) Installation Menu Chart
LEVEL A LEVEL B LEVEL C LEVEL D (see manual) LEVEL E LEVEL F
Display Setup Select Data Enter From List
Data Display Enter From List
Time Base Enter From List
Stripchart Clear Yes/No
Logger Setup Logger Mode Enter From List
Logger Data Enter From List
Logger Interval Enter From List
Logger Events Enter From List
Display Logger Enter From List
I/O Data Control Analog Out Setup Enter From List
Relay Setup Relay 1,2,3,4
Analog Inp Setup Enter From List
Diagnostic Data Path Select 1, 2, 1 & 2
Path Enable No/Yes
Flow Data Enter From List
Application Info Enter From List
Liquid Data Enter From List
Site Setup Data Enter From List
Test Facilities Enter From List
Print Site Setup No/Yes
Site Created: View Only mm.dd.yy hh.mm.ss
Meter Facilities Preferred Units English/Metric
Table Setups Pipe Table Create/Edit Pipe Enter From List
Delete Pipe Enter From List
Sensor Type Enter From List
Logger Control Display Logger Off/Line Wrap/No Line Wrap
Output Logger Yes/No
Circular Memory Yes/No
Est LogTime Left View Only
Clear Logger Yes/No
Memory Control Log Memory Left View only
Memory Map Yes/No
Defragment Yes/No
Analog Out Trim Trim Io1 Operate
Trim @ 4mA
Trim Io2 Operate
Trim @ 4mA
Trim Vo1 Operate
Trim @ 2V
Trim Vo2 Operate
Trim @ 2V
Trim Pgen1 Operate
Trim @ 1 kHz
Trim Pgen2 Operate
Trim @ 1 kHz
RTD Calibrate RTD 1 Factory
User Cal
RTD 2 Factory
User Cal
Clock Set Date (MM.DD.YY) Edit Date
Time ((HH.MM) Edit Time
RS-232 Setup Baud Rate Enter From List
Parity Enter From List
Data Bits 7/8
Line Feed Yes/No
Network ID Numeric Entry
RTS Key Time Enter From List
Backlight Enter from List
System Info Version View Only
Reset Data/Time View Only mm.dd.yy hh.mm.ss
Op System P/N View Only
Checksum View Only
Code View Only
System Time View Only mm.dd.yy hh.mm.ss
Language Enter From List