Siemens SITRANS FX330 - Page 70

6 OPERATION
70
SITRANS FX330
www.siemens.com/flow 08/2022 - A5E36751269-AG EN
C Setup C1 Process C1.11 Normal Values C1.11.1 Norm. Temperature
C1.11.2 Norm. Pressure
C1.11.3 Norm. Density
C1.12 Heater/Cooler
C2 Output C2.1 Current Output C2.1.1 Current Out. Meas.
C2.1.2 0% Range
C2.1.3 100% Range
C2.1.4 Lower Ext. Range
C2.1.5 Upper Ext. Range
C2.1.6 Error Function
C2.1.7 Low Error Current
C2.1.8 High Error Current
C2.1.9 Trimming
C2.2 Binary Output C2.2.1 Function
C2.2.2 Pulse Output
C2.2.3 Frequency Output
C2.2.4 Status Output
C2.2.5 Limit Switch
C2.2.6 Invert Signal
C3
Communication
C3.1 HART C3.1.1 Current Loop Mode
C3.1.2 Identification
C3.1.3 Device Information
C3.1.4 HART Variables
C3.1.5 Catch DV Temp.
C3.1.6 Catch DV Pressure
C4 Totalizer C4.1 Flow Totalizer C4.1.1 Measurement
C4.1.2 Preset Value
C4.1.3 Reset Totalizer?
C4.1.4 Set Start Value
C4.1.5 Start Totalizer?
C4.1.6 Stop Totalizer?
C4.1.7 Information
C4.2 Energy Totalizer C4.2.1 Measurement
C4.2.2 Preset Value
C4.2.3 Reset Totalizer?
C4.2.4 Set Start Value
C4.2.5 Start Totalizer?
C4.2.6 Stop Totalizer?
C4.2.7 Information
Meas. Menu C Submenus
> ↲ ↓ ↑ > ↲ ↓ ↑ > ↲ ↓ ↑ > ↲ ↓ ↑ >