3. Mount SENSORPROM
®
in remote transmitter.
4. Fit M20 or ½" NPT cable glands on sensor terminal box.
5.
Fit and connect electrode and coil cables as described in Connecting (Page 31).
Note
Unscreened cable ends must be kept as short as possible.
Electrode cable and coil cable must be kept separate to prevent interference.
6. Tighten cable glands and lid screws well to obtain optimum sealing.
WARNING
Mount terminal box lid before power up.
Installing/Mounting
4.4 Remote installation
26
SITRANS MAG 6000 I/6000 I Ex de
Operating Instructions, 08/2018, A5E02083319-AH
To Next Page
Loading...
