Siemens SITRANS MAG 6000 I - External Input; A.10 External Input

A.10 External input
7RWDOL]HUUHVHW
7
RWDOL]HU
)RUFHRXWSXW
7RWDOL]HU
7RWDOL]HU
7RWDOL]HU
([WHUQDOLQSXW
2II
6WDUWEDWFK
+ROGFRQWLQXH
6WRSEDWFK
7RWDOL]HUUHVHW
7RWDOL]HUODS


)RUFHRXWSXW
)
UHH]HRXWSXW
4PD[QLJKW
0DQXDOFOHDQLQJ


2II
([W
HUQDOLQSXW
*
1) The value showing totalizer 1 on the display is frozen for as long as the digital output is activated.
However,
totalizer 1 continues counting, and when the digital input is released, the value on the
display again follows totalizer 1.
2) MAG 6000 I cannot be equipped with cleaning unit. The cleaning option for relay output is
however possible. When selecting function for MAG 6000 I relay output, the relay output has
the same behavior as if cleaning unit was installed.
The relay output of the transmitter determines when the relay is on by applying voltage for
approximately 60 seconds. The metering is resumed after another 60 seconds when the cycle
is
complete. (The display is locked during this time). The time cycle can be set at 1 to 240 hours.
If the cycle is set at for example three hours, the transmitter will be active every three hours.
Menu diagrams
A.10 External input
82
SITRANS MAG 6000 I/6000 I Ex de
Operating Instructions, 08/2018, A5E02083319-AH