Siemens SITRANS SCM IQ - Mounting on DIN Rails

PP
PP
PP
PP
5.1.3 Mounting on DIN rails
Before you install the device
• You have installed a DIN rail with 35 mm standard pro󹪝le at the installation site.
Procedure
Installing the device
1. Place the device and rail clip on the upper
edge of the standard pro󹪝le rail at the posi‐
tion shown and push the device down.
2. Swing the rail clips of the device from below
via the standard pro󹪝le rail.
3. Push the device in the direction of the stand‐
ard pro󹪝le rail. You will hear the device click
into place.



Installing/mounting
5.1 Installation instructions SITRANS CC220
Smart Condition Monitoring with IIoT Sensors
26 Operating Instructions, 08/2021, A5E50573389-AA