Siemens SITRANS SCM IQ - Commissioning SITRANS MS200 with SITRANS SCM IQ

19.Remove the USB stick.
20.Check the operating state of SITRANS CC220 in SITRANS SCM IQ in the "Device
con󹪝guration" tab:
– green: connected
– yellow: connection in progress
– red: disconnected
It may take several minutes for the operating state to show in SITRANS SCM IQ.
Repeat this procedure for each SITRANS CC220.
7.7 Commissioning SITRANS MS200 with SITRANS SCM IQ
The following procedure describes how to connect SITRANS MS200 sensors with
SITRANS SCM IQ. Each SITRANS MS200 needs to be assigned to a SITRANS CC220 gateway and
mapped to a speci󹪝c Asset in the Asset structure in MindSphere (see Integrating SITRANS MS200
to MindSphere Asset Manager (Page 40)).
For more information, watch this video (https://www.youtube.com/watch?
v=AJLLbYmtN2A&t=258s).
Required user roles
• Required user roles without MindSphere Subtenants:
– MindSphere user role: TenantAdmin or StandardUser
– SITRANS SCM IQ user role: sitransscmiq:admin
• Required user roles with MindSphere Subtenants:
– MindSphere user role: SubtenantUser
Note: Do not use TenantAdmin when using Subtenants. Subtenant can not see devices
and assets of other subtenants.
– SITRANS SCM IQ user role: sitransscmiq:admin
Commissioning
7.7 Commissioning SITRANS MS200 with SITRANS SCM IQ
Smart Condition Monitoring with IIoT Sensors
Operating Instructions, 08/2021, A5E50573389-AA 43