Siemens SITRANS SCM IQ - 11 Technical Specifications; Technical Specifications SITRANS CC220

Technical speci󹪝cations
11
11.1 Technical speci󹪝cations SITRANS CC220
General technical speci󹪝cations
Weight without mounting brackets Approx. 250 g
Power supply
1
9 ... 36 V DC, no electrical isolation to: USB, RS485, Antenna
GND. Isolation present to Ethernet ports
Brief voltage interruption in accord‐
ance with NAMUR
Up to 5 ms bu󹪜er time at 24 V DC and full load
2
maximum 10 events per hour; recovery time at least 10 s
Current consumption Max. 1.4 A
Noise emission < 40 dB(A) according to DIN 45635-1
Degree of protection IP20 according to IEC 60529
Quality assurance In accordance with ISO 9001
1
The device should only be connected to a power supply which satis󹪝es the requirements of safe extra
low voltage (SELV) according to IEC/EN/DIN EN/UL 60950-1. The power supply must meet the NEC Class
2 or LPS requirement according to the IEC/EN/DINEN/UL 60950-1.
2
In the event of low supply voltage, the bu󹪜er time is reduced
Interfaces
LAN interface RJ45 10/100 Mbps X1P1LAN: Internet for example MindSphere
Antenna extension cord (optional)
Type WLAN extension cord, SMA male, SMA female
Length Max. 2 m
Impedance Coaxial 50 Ohm
USB stick speci󹪝cations
Type USB 2.0 Type A
Supported formatting FAT32
Climatic Ambient conditions
Permitted mounting positions. See section "Mounting positions and mounting types (Page 25)“.
Ambient temperature
Smart Condition Monitoring with IIoT Sensors
Operating Instructions, 08/2021, A5E50573389-AA 69