Dismantling the device
1. Push down the device until it is released by the rail clips.
2. Swing the device out of the standard prole rail.
3. Lift the device up and o.
5.1.4 Mounting on a wall
The device is suitable for horizontal or vertical wall mounting.
Before you install the device
You need the following:
• Four push-in lugs
The push-in lugs must be ordered separately, see section "Accessories (Page 77)"
• Four anchors and four screws
Installing/mounting
5.1 Installation instructions SITRANS CC220
Smart Condition Monitoring with IIoT Sensors
Operating Instructions, 08/2021, A5E50573389-AA 27
To Next Page
Loading...
