Siemens SITRANS SCM IQ - Installing SITRANS MS200 on a Pump or Compressor; Installing SITRANS MS200 on a Gear; Installing SITRANS MS200 on Rotating or Vibrating Equipment

5.2.3 Installing SITRANS MS200 on a pump or compressor
Mount SITRANS MS200 near the liquid inlet directly on the pump.
Note
SITRANS MS200 must not get in direct contact with chemicals.
NOTICE
Maximum speci󹪝ed ambient temperature
The maximum speci󹪝ed ambient temperature must not be exceeded by the pump or
compressor. See Technical speci󹪝cations SITRANS MS200 (Page 71).
5.2.4 Installing SITRANS MS200 on a gear
Mount SITRANS MS200 directly on the gear. The most suitable place is at the middle of the gear
in the horizontal position.
NOTICE
Maximum speci󹪝ed ambient temperature
The maximum speci󹪝ed ambient temperature must not be exceeded by the gear. See Technical
speci󹪝cations SITRANS MS200 (Page 71).
Note
SITRANS MS200 must not get in contact with gear oil or gear oil vapors.
5.2.5 Installing SITRANS MS200 on rotating or vibrating equipment
Any rotating or vibrating equipment can be supervised with SITRANS MS200. Mount SITRANS
MS200 as close as possible to vibrating components.
NOTICE
Maximum speci󹪝ed ambient temperature
The maximum speci󹪝ed ambient temperature must not be exceeded by the rotating or
vibrating equipment. See Technical speci󹪝cations SITRANS MS200 (Page 71).
Installing/mounting
5.2 Installation instructions SITRANS MS200
Smart Condition Monitoring with IIoT Sensors
Operating Instructions, 08/2021, A5E50573389-AA 31