Procedure
1. Switch o the power supply.
2. Connect the lines to the connecting terminal with a torque of 0.56 Nm (5lb-in).
3. Connect the connecting terminal to the connection for the power supply.
⇒ PWR LED lit.
⇒ User LED is ashing.
4. Integrate the device into your network using Ethernet port X1P1LAN.
The network conguration is described in chapter Administrating the network for SITRANS
CC220 (Page 38).
5. Make sure the device has an internet connection.
Connecting SITRANS CC220
6.2 Connecting SITRANS CC220
Smart Condition Monitoring with IIoT Sensors
Operating Instructions, 08/2021, A5E50573389-AA 35
To Next Page
Loading...
