6. Turn SITRANS MS200 180° and use a suitable tool (e.g. a at-head screw driver) to lift up the
snap ⑥ on the front.
Note
Tool must not touch the PCB.
7. Take o the battery holder cap ⑦.
8. Lift and exchange the battery pack with a Siemens specied battery pack (see Battery pack
specication (Page 18)). Ensure that the positive terminal of the battery pack points upwards.
9. Wrap the cable in its original position using the dedicated snaps of the battery holder.
Service and maintenance
9.2 Maintenance and repair work for SITRANS MS200
Smart Condition Monitoring with IIoT Sensors
Operating Instructions, 08/2021, A5E50573389-AA 61
To Next Page
Loading...
