Mobility, Intelligent Traffic Systems
Sopers Lane, Poole, Dorset, BH17 7ER
By default, the controller has no licences fitted and those required must be ordered
and installed on the controller.
Distribution and Storage of Licences
Licences are distributed and held on the ST950 in Smart Cards. For distribution
either a full size (credit card size) or SIM size Smart Card can be used. For storage
on the ST950, a SIM size Smart Card is used and is fitted in the Smart Card holder
on the CPU Card.
Installing Licences on the Controller
If no Licence Smart Card is fitted in the controller, the following procedure should be
followed to fit the Smart Card:
• Power down the controller.
• Unplug connectors and slide the card free of the rack so that the top edge of
the card can be accessed.
• Rotate the locking ring as shown below to unlock the container.
No Card – Locked No card - Unlocked
• Carefully lift the end of the container as shown below.
No Card, container Open
• Slide the licence card with the contacts facing the PCB into the raised section
of the holder noting the card orientated shown below – ensure that the card is
fully inserted.
To Next Page
Loading...
